Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 27)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 21
Sugaring Tray and Roto Cooler
SPECIFICATIONS
Dimensions Shipping
Weight
Electrical Data Construction Standard
Equipment
Dia.=17-1/4”/
44 cm
H=6-5/8”/17 cm
16 lb/7.3 kg
120 V
1 Phase
50 or 60 Hz
Spun, polished,
heavy-gauge
aluminum. Power turntable with
sugar tray.
Figure 4-6. Sugaring Tray.
The Roto Cooler base makes the Sugaring Tray
rotate. It is meant to be used on a flat, stationary
table or countertop.
The Sugaring Tray, which mounts on the Roto
Cooler base, is designed to catch donuts as they
drop from the outfeed end of the Donut Robot,
and to hold toppings in which donuts can be
dipped. The operator is expected to read and
follow these instructions.
To use the Sugaring Tray and Roto Cooler base:
1. Put sugar, powdered sugar, or cinnamon-
sugar in the tray.
2. Place the Sugaring Tray and Roto Cooler
base near the outfeed end of the Donut
Robot so donuts will fall into the tray.
3. Connect the Roto Cooler power cord to the
120 V outlet on back of the Donut Robot’s
heater head.
4. Turn on the Roto Cooler base. The Sugaring
Tray will rotate and receive donuts.
5. Coat the donuts with the topping in the tray.
6. When you are finished using the Sugaring
Tray, turn off and unplug the Roto Cooler
base.
WARNING
To avoid electrocuting yourself or
damaging the machine, never submerge the
base of the Roto Cooler.
7. Clean the Sugaring Tray using soap and
water and a non-abrasive cloth or scrubber.