Beurer GL 50 evo (mgdl) - Manual (Page 23)

Beurer GL50 evo mg/dL 23
5.4 Reading the result and labelling measurements
Read the result
As soon as the blood input gap is filled with sufficient
blood, the device performs the blood glucose measure-
ment. The blood glucose monitor counts down for ap-
prox. five seconds. The measured result is then shown
on the display.
Read your measured value. Check again that you have read the result correctly. The underline must be
below the measured value, otherwise you need to turn the monitor by 180°. For explanations of and
measures regarding the measured values, see “5.6 Evaluating measured blood glucose values” on
page 23. If an error message is displayed, read chapter “8. What if there are problems?” on page 33.
Label measured value
You have the following options for labelling measured values.
Before a meal
After a meal
General label (e.g. after exercising)
Labelling measured values enables you, your GP or diabetes consultant to better monitor your blood
glucose values. For example, you can display the average values of all measurements taken before
a meal.
To label a measurement, proceed as follows:
1 Following the measurement, the display will briefly show the measured value and then the
menu in which you can mark the measured value. It is not possible to mark the measured
value afterwards.
2 Select the desired marking using the scroll wheel.
O No marking
Before a meal
After a meal
General label
Confirm the marking by pressing the scroll wheel.
The selected marking is now allocated to the measured value and saved to the memory.
3 The selected label is stored in the memory of the device when it is switched off.