Beurer GL 50 evo (mgdl) - Manual (Page 24)

24 Beurer GL50 evo mg/dL
5.5. Post-processing and disposal
1 Remove test strip
Remove the test strip from the device and carefully dispose of it in
accordance with the applicable regulations to avoid infecting others.
2 Remove cap
Carefully remove the cap from the lancing device.
3 Stick protective disc on needle
Place the retained protective disc flat on a hard surface. Stick the
tip of the needle into the protective disc (image 1) so the needle is
covered (image 2).
Image 1 Image 2
4 Remove and dispose of lancet needle
Press the trigger again so that you can grip the shaft. Carefully remove
the lancet needle from the lancing device and dispose of the lancet
in a puncture-proof container.
Carefully dispose of all blood samples and materials that you have
come into contact with. This prevents injuries and the infection of
others.
5 Replace cap
Place the cap back on the device. Turn the clip back over the cap.
5.6 Evaluating measured blood glucose values
Your blood glucose monitor can process values between 20 and 630 mg/dL. The “Lo” warning is
displayed for measured results below 20 mg/dL. The “ ” warning is displayed for measured results
above 630 mg/dL.