Compuprint 9058 - Manual (Page 92)

86
Storing the values
TEAR ADJUST: xxxx
↑
STORE? QUIT → or ←
STORE? SAVE → or ←
STORE? CURRENT → or ←
PROG
EXIT
STORE? QUIT This setting does not save any of the new values set. The values set previously
will be used.
STORE? SAVE The values set are stored permanently (in the NVM) and will be used until
they are changed by the operator.
STORE? CURRENT The values set are valid until the printer is turned off. When you turn the
printer on again, the values set in the preceding menu setup will be used.
At this point the Program Configuration Setup is finished. You exit pressing the PROGRAM key.