Entone Hydra II User Manual
Page 21
Copyright
2007 Entone, Inc. All rights reserved
19
Chapter
5
5.1
Connecting TV(s) In Other Rooms
This section describes how to connect the Hydra to the cable-ready remote TV(s) located in other room(s)
away from the Hydra. This installation uses your in-home TV cabling system. If your house does not have
built-in TV cabling, it will be necessary to run cables from the Hydra to each remote TV. Due to the difficulty
of this installation, you should consider having this professionally installed.
If connecting to the in-home cabling system to distribute the signal to TV(s) in other rooms, in most
cases, you will not have to install the attenuator on the “MATV OUT” port for typical in-home cabling
systems.
If connecting directly to a TV tuner port, you must install the attenuator in the cable between the “MATV
OUT” port and the TV tuner.
Figure 5-1 Connecting the Attenuator