Entone Hydra II - Manual (Page 30)

Hydra User’s Guide
Copyright     2007 Entone, Inc. All rights reserved . 28
REMOTE CONTROL REGISTRATION
For the new Hydra Remote Control (that has three LED back light on Myrio, TV and AUX key), we have
introduced a new and simpler remote control registration method via RF and thus the remote control
antenna must be installed. Do the followings to register a remote control:
1. Press and hold the OK button on the Hydra front panel for about 5 seconds. When the OK button is
released, the Hydra front panel Standby/On indicator blinks twice (alternates red and green) and then
stays lit red to indicate that the Hydra is now in remote registration mode.
Figure 9-4 Hydra in Remote Registration Mode
2. On the remote control, press and hold the “STB” button for approx. 5 seconds. The “STB” button
backlight will illuminate. Now the remote control is in registration mode.
Figure 10-5 Remote Control in Remote Registration Mode
3. Select the decoder to register by:
Press “1” to register remote control to decoder 1.
Press “2” to register remote control to decoder 2.
Press “3” to register remote control to decoder 3.
Press “0” to set remote control to IR mode only. The remote control will not send any RF signal.
After you enter a registration event, the “STB” button backlight on the remote control and the Hydra
front panel Standby/On indicator will blink twice to indicate that the registration process was
successful.
Pressing a key other than “0”, “1”, “2”, “3” or if a button is not pressed within 10 seconds, the “STB”
backlight will extinguish and the remote control registration process will be terminated. The STB
backlight LED on the remote control handset and the front panel LED will blink twice to indicate that
the registration process was successful.