ESI Waveterminal 192L - Manual (Page 23)

ESI Waveterminal 192
24
<Waveterminal 192L PCI card>
1. MIC IN
This is MIC input of Waveterminal 192L. You can use dynamic or condenser
microphone and it supplies +12V DC phantom power. You cannot use MIC input and
Line input at the same time. You can choose MIC input or Line input on the control
panel of 192L.
When you use condenser MIC, you can turn on/off phantom power switch on the
control panel.
2. LINE IN -Analog Input(stereo)
This is analog Line input. It is stereo +4dBu Unbalanced connection. You cannot use
this Line input and MIC input at the same time.
3. 4. Analog 1,2/3,4 Output (stereo)
These are stereo Analog Outputs. Analog 1,2 send out the signal indicated as ‘1-
waveterminal 192 2ch’ on application’s device set up. Analog 3,4 send out the signal
indicated as ‘2-waveterminal 192 2ch’ on application’s device set up. Using TRS 55
phone plug, send two signal from one output port.