ESI Waveterminal 192L - Manual (Page 35)

ESI Waveterminal 192
36
1. Pull Down Menu
The Waveterminal 192L
control panel includes a pull down menu bar that contains the
configuration menus for the Control Panel.
1. File - Exit
File – Exit will close the Waveterminal 192L
Control Panel window but it will not shut
down the Control Panel. You can always launch the Control Panel by clicking icon
on the system tray.
2. Config – Mouse Wheel
Mouse Wheel will control the mouse wheel adjustment. When you use the mouse wheel
to adjust the volume level, the adjustment step is set to
±1.5dB as default. You can
configure the adjustment steps to your preference.
- Step 1: When you move the mouse wheel one step, the fader will move by
±1.5dB.
- Step 2: When you move the mouse wheel one step, the fader will move by ±3.0dB.
- Step 4: When you move the mouse wheel one step, the fader will move by ±6.0dB.
- Step 8: When you move the mouse wheel one step, the fader will move by ±12.0dB.
3. Config – Latency
This will decide the latency of the Waveterminal 192L. You have to set proper latency
depends on your situation. Generally, higher latency is fit for Multi-track recording
software using multiple tracks. Process time maybe longer, but it’s stable. Lower latency
is fit for software synthesizer, mastering software or Multi track software using only
few tracks.
4. Config – Factory Default
This returns all the Waveterminal 192L configurations to factory default setting.
5. Config - Always On Top
This will set the Waveterminal 192L control panel to always over other Windows. If this
is not selected, the active windows will be set over the Waveterminal 192L control panel.
6. Config – Card (This section is for future use)