Flowserve 3400IQ Digital Positioner - Manual (Page 45)

4
Logix 3400IQ Digital Positioner FCD LGENIM3402-00 – 0/07
flowserve.com
Table 8.3 Resource Block Parameters
Index Name Data Type/Structure Store Default Value
35 UPDATE_EVT Event - update D
36 BLOCK_ALM Alarm - discrete D
37 ALARM_SUM Alarm - summary MIX
38 ACK_OPTION Bit string S 0
39 WRITE_PRI Unsigned8 S 0
40 WRITE_ALM Alarm - discrete D
Valtek Device Products Parameters
41
DL_CMD1 Unsigned8 D
42 DL_CMD2 Unsigned8 D
43 DL_APPSTATE Unsigned16 S
44 DL_SIZE Unsigned32 S
45 DL_CHECKSUM Unsigned16 S
46 REVISION_ARRAY Unsigned32 S
47 BLOCK_TEST Unsigned8 D
48 ERROR_DETAIL Unsigned16 D
* OOS = Out-of-service
Resource Block Valtek Product-defined Parameter Descriptions
Table 8.4 describes the Valtek product-defined parameters in the resource block, which are used
during the application download procedure.
Table 8.4 Resource Block Parameter Descriptions
Name Description or Parameter Contents
DL_CMD1
DL_CMD2 Used to unlock or access the domain (flash memory area) of the device
for download. Entering a series of values in these two parameters
changes the internal state of the device so that it will accept the
downloaded application software. The download cannot begin until the
device is put into the correct internal state. The internal state of the device
is read in the DL_APPSTATE parameter.
DL_APPSTATE Contains the state of the downloaded(ing) application.
DL_SIZE Contains the size of the downloaded application. (This will always be an
even number.)
DL_CHECKSUM Contains the 16-bit check-sum of the downloaded application.
REVISION_ARRAY A read-only parameter that contains the application firmware revision
level for:
Fieldbus board application
Fieldbus board boot code
Positioner board application.
BLOCK_TEST An internal Valtek product test parameter.
ERROR_DETAIL An internal Valtek product parameter array, which contains details of
BLOCK_ERR conditions.