GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module - Manual (Page 16)

Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module Page 14 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
DTMF with Voice Switch
Volume Level - Select the speaker output level using the slide bar. The valid range is 4 mW to 8 W in
doubling increments (4 mW, 8 mW, 16 mW, etc.).
Automatic Level Adjust – This feature is not compatible with the 10458-10x series Paging Modules.
Always use the setting Disabled.
Test Tone Volume Adjust – The unit will generate a tone at the current volume setting when it enters
the test tone mode. This entry sets the duration of the test tone. When the unit volume is adjusted (in test
tone mode), the unit will generate a tone at the newly selected level. The valid range is 0.5–6.0 seconds
in 0.5-second increments.
Voice Switch - Select the silence limit using the slide bar. The unit will return to inactive (sleep) mode
if audio is not received in this amount of time. The valid range is 3–10 seconds in 0.5 second increments.
DTMF Address & Description 1–8
Enter the DTMF addresses to activate the paging module. A description of up to 12 characters can be
entered for each address. Each address can contain up to eight digits. Up to eight different addressed can
be programmed.