Programming the radio – GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module User Manual
Page 19
Advertising
Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module
Page 17 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
Programming the Radio
1. Make sure the radio to be programmed is powered and connected to the PC (as described above)
before starting the programming software on the PC.
N
OTE
: If the Ritron software does not read the type of the connected radio, unplug the programming
cable and re-insert.
2. The radio’s current programming will be displayed. Below is an example:
N
OTE
: The Electronic Paging Module uses only the frequency programmed for channel 8. Be sure
to program channel 8 with the licensed frequency. The RF Module is capable of being
programmed for channels 1–8.
Advertising
This manual is related to the following products: