GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module - Manual (Page 9)

Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module Page 7 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
Fuses
There are two fuses (F1 and F2) located on the speaker amplifier PCBA
Fuse F1 is a 3-amp fuse that limits the current draw from the 12 V dc power supply. Replace F1 with
Littelfuse (3 amp) 5 × 20 mm or Cooper Bussman (3 amp) 5 × 20 mm fuses only.
Fuse F2 is a 5-amp fuse that limits the current draw from the 12 V dc battery. Replace F2 with Littelfuse
(5 amp) 5 × 20 mm or CooperBussman (5 amp) 5 × 20 mm fuses only.
Card Suite Software
Installation
Exit all other programs that are running until the installation is complete.
Place the flash drive in the computer USB port.
If the installation does not start up automatically, it can be run from the Start menu. Select the Start
button; then select Run. At the prompt, type x:\Software Select Menu.exe where x represents the
drive letter that is associated with your flash drive. A CARD Suite icon should appear on the desktop
display after successful installation.
Connecting the Programming Cable
1. Attach the programming cable to the COM1 or COM2 serial port connector on the computer using
the 9-pin adaptor supplied with the cable.
N OTE : If using a USB-to-RS-232 converter, connect the converter to the computer’s USB port and
then connect the programming cable to the 9-pin mating receptacle on the converter.
2. After opening the paging module (as previously described), plug the programming cable into the
programming connector J1 on the speaker amplifier PCBA. Refer to Figure 3.
3. Connect a 12 V dc power source to the terminal block labeled BATTERY, located on the front
section of the paging module assembly. Be sure to observe the voltage polarity.
4. Verify the Power LED and the Programming LED illuminate on the speaker amplifier PCBA. The
Power LED indicates the 12 V dc is properly connected and the Programming LED verifies the
computer and programming cable are connected properly.