GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module - Manual (Page 25)

Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module Page 23 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
Wiring and Connections
The paging module provides terminal blocks on the front of the assembly for all field wiring. Each
terminal block is labeled to indicate the functionality. Refer to Figure 6 for a sample wiring diagram.
1. After installing all speaker kits and antenna kit (for RF installations), make sure all wires & cables
from the components are at the bottom of the 234 Series Stanchion.
2. Connect the black/white and white/black speaker wires to the 4-point speaker connector. Speakers 1
and 2 are parallel wired onto terminals labeled 1 & 2 . Speakers 3 and 4 are parallel wired onto
terminals labeled 3 & 4 .
3. For hardwired audio installations:
 Connect the audio input wires to the terminals labeled A
UDIO I NPUT L1&L2 . Polarity for the
audio wires is not important. The audio cable must be a twisted pair to prevent noise pickup on
the line.
 Connect the contact closure input wires (if used) across the terminals labeled
P AGE C TRL + and –.
4. For RF installations, plug in the BNC connector on the antenna cable into the paging module.
5. Connect the battery wires to the battery connector observing the + (red) and (-) black polarity.
6. Connect the violet and orange wires from the GAI-Tronics Model 530-001 Strobe Light to the
terminals labeled O
UTPUT C TRL + and -. Polarity is important: violet wire (+), and orange wire (-).
7. Remove the cover from the power terminal block. Connect the 120/240 V ac power wires observing
the H, N and GND labels. Replace the cover before applying power.