Gasboy Electric Keytrol - Manual (Page 12)

GASBOY Electric Keytrol
3-2 03/28/03
GENERAL INSTRUCTIONS
Upon receiving, perform the following:
1.
Unpack carefully and report any damage immediately.
2.
Using the door key, unlock and open door. (Door opens only 90
°
, so do not force it beyond
this point.)
3.
Using the bezel key, remove the bezel by pulling gently outward and down after clearing the
bottom, front of the cabinet. (NOTE: Do not overtighten bezel locks. Tighten lock with key
making 3 to 4 complete turns.)
4.
Ensure that all screws holding the modules are in place and tight.
5.
Ensure that all terminal block screws are tight.
6.
Ensure that no damage has occurred during shipment. Report any damage immediately.
7.
Ensure that the time delay relay is properly installed in the upper octal socket (not available
on Split Dual Pump Control units).
CAUTION! Relay and socket are “keyed”, so be careful to align these properly when
reinstalling.
8. Ensure that the missing pulse detector is set for 15 seconds (not available on Split Dual
Pump Control units).
Factory-Mounted Units on a Pump or Dispenser
Follow installation instructions supplied with pump or dispenser.
Field-Mounted Master or Auxiliary Electric Keytrol
IMPORTANT: Do not install in Class 1, Division 1 or Division 2 hazardous location.
1.
When mounting on a wall or post, the use of a shelf is recommended; order GASBOY P/N
014632.
2.
Auxiliary Keytrol units must be of the appropriate power rating. Units are available for 115
VAC or 230 VAC applications.
3.
Install wires in accordance with the National Electrical Code (NFPA 70). Also, all wiring must
conform with local electrical codes. Units must be properly grounded.
4.
Seal conduit as per NEC requirements.