Gasboy EQ 25 XXX - Manual

MDE-4485 Gasboy Pulser Kits X:1 EQ 25 XXX Installation • June 2005 Page 1
Introduction
This manual provides installation instructions for the following Gasboy Pulser Kits:
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tools
The following tools are needed to install the Pulser Kits:
• Standard Wrench Set
• Flat tip screwdriver
• Cross tip screwdriver
• Punches (to remove and install pins)
Kit number Kit Description
032796 Pulser Kit X:1 EQ 25 GAS
033088 Pulser Kit X:1 EQ 25 LTR GAS
033140 Pulser Kit X:1 EQ 25 LTR DSL
033148 Pulser Kit X:1 EQ 25 DSL
MDE-4485
Gasboy Pulser Kits X:1 EQ 25 XXX
Installation
June 2005