6 enter the license number, 7 enter the limit code, 8 enter the authorization code – Gasboy Fuel Point Vehicle Module User Manual
Page 36: 9 odometer is the first field counter that appears
Advertising
Operation
Programmer Operating Modes
Page 5-8
MDE-4524A Vehicle Module Programming Manual· May 2006
6
Enter the License number.
Note: Since this is an alphanumeric field, you must press ENTER to advance to the next
character position.
7
Enter the Limit code.
8
TUV
YES
ENTER
ENTER LIMIT:
8
8
Enter the Authorization code.
YES
ENTER
1
ENTER AUTH.
1
9
Odometer is the first field counter that appears.
YES
ENTER
SEL ODOMETER - 0
0_ HOURS - 1
0
QZ
10
When programming a newly installed VM, it is a good idea to test the installation. Press
ENTER at the following prompt to set the odometer at 0000000.0. The correct initial reading
of the odometer is loaded after testing the odometer connection.
YES
ENTER
ENTER ODOM [1]
???????.?
Advertising