Gasboy Fuel Truck Controller - Manual (Page 60)

Fuel Truck Controller Manual 54
NOTE
Pulser should be installed in accordance with the
pulser manufacturer's instructions. Some pulsers do
not have a barrier. In that case you must add a pulser
barrier! Barriers and nozzle rings are not provided
with Fuel Truck Controller
Barriers and nozzle rings must be installed on truck
as UL Listed by Report Retrofit kits prior to the
installation of the Fuel truck controller.
3-9.2.1. Electronic Pulser
 3-Wire Pulser - requires an external power source in order to operate
Figure ‎3-13 shows a schematic diagram of the connections between the Terminal Block and a
3-wire Pulser.
Figure ‎3-13 Terminal Block and 3-Wire Pulser – Wiring Connections
3-9.2.2. Mechanical Pulser
 2-Wire Pulser, powered by the Fuel Truck Controller.
Figure ‎3-14 shows a schematic diagram of the connections between the Terminal Block and a
2-wire Pulser.