Gasboy Fuel Truck Controller - Manual (Page 66)

Fuel Truck Controller Manual 60
Figure ‎4-2. Printer Harnesses
To install the Printer in the driver's cabin (non hazardous location), proceed as follows:
1. Set the Mobile Printer enclosure (with mounting bracket) in the spot and mark the four
holes location from the bracket for drilling, Verify that the selected place does not
interfere with the driver's ability to drive safely
2. Drill four holes in the installation spot
3. Secure the bracket with the provided four screws
4. Secure the Mobile Printer to the mounting bracket with the provided four screws
5. Connect the Printer Harness to the Printer Connector
6. Connect the Printer Harness P/S wires (Black and Red) to 12 VDC Power Supply
7. Connect the Printer Harness D-Type 9 pins female connector to the RS-232 Harness
8. Connect the RS-232 Harness to the COM2 RS-232 connector on the OrCU