GBS Elektronik MCA-527 Firmware Commands - Manual (Page 19)

Description of the MCA527 Firmware Commands
MCA Data Setup Commands:
Command name CMD_SET_TDF
Compatibility
Compatible to the MCA166 command. The command is meaningless for the MCA527. It has only
been retained for compatibility with older software
Execution right Necessary
Description The command does nothing. It has only been retained for compatibility with older software
Format integer integer integer long integer
Parameter preamble command tdf 0 end flag
Byte string (HEX) A5 5A 61 00 tdf
l
tdf
h
0 0 0 0 B9 9B
Remarks The command is meaningless for the current firmware version. Possibly, future firmware will use the
parameter again.
Command name CMD_SET_UF6_ROIS
Compatibility Compatible to the MCA166 command.
Execution right Necessary
Description The command sets the begin and the end of a ROI used by the other UF6 commands. The name of
the command refers to its original usage.
r:
ROI number (1, 2 or 3)
b: ROI begin
e: ROI end
Up to firmware version 14.01: b < e < max. channels number, (e − b) < 512.
Since firmware version 14.02: b < e < max. channels number
If b = 0 and e = 0, the corresponding ROI is reset to “not used”.
Format integer integer integer integer integer integer
Parameter Preamble command r b e end flag
Byte string (HEX) A5 5A 64 00 r 00 b
l
b
h
e
l
e
h
B9 9B
Command name CMD_SET_USER_DATA
Compatibility Compatible to the MCA166 command.
Execution right Necessary
Description The command stores any 32 bit value (val) in the MCA memory (256 entries).
e: 0 ... 255
entry number
Format integer integer integer 32 bit integer
Parameter preamble command e val end flag
Byte string (HEX) A5 5A 57 00 e 00 … ... ... ... B9 9B
Remarks See also document “Use of MCA User Data Memory by Specific Applications”.
19