GBS Elektronik MCA-527 Firmware Commands - Manual (Page 54)

MCA527
Name CMD_QUERY_ADJUSTMENT_TABLE
Compatibility New MCA527 command.
Execution right Not necessary
Description The command returns the ADC values that has been measured with different settings at open signal
input. These data can be used to interpolate
the ADC value which corresponds to the ground
line. A value is valid if it is unequal to -1.
Format integer integer integer long integer
Parameter Preamble command 0 0 end flag
Byte string (HEX) A5 5A 26 01 00 00 00 00 00 00 B9 9B
Result data array
Byte offset 0 measured with coarse gain = 2, offset DAC = 1024 short
Byte offset 2 measured with coarse gain = 2, offset DAC = 15360 short
Byte offset 4 measured with coarse gain = 5, offset DAC = 1024 short
Byte offset 6 measured with coarse gain = 5, offset DAC = 15360 short
Byte offset 8 measured with coarse gain = 10, offset DAC = 1024 short
Byte offset 10 measured with coarse gain = 10, offset DAC = 15360 short
Byte offset 12 measured with coarse gain = 20, offset DAC = 1024 short
Byte offset 14 measured with coarse gain = 20, offset DAC = 15360 short
Byte offset 16 measured with coarse gain = 50, offset DAC = 1024 short
Byte offset 18 measured with coarse gain = 50, offset DAC = 15360 short
Byte offset 20 measured with coarse gain = 100, offset DAC = 1024 short
Byte offset 22 measured with coarse gain = 100, offset DAC = 15360 short
Byte offset 24 unused 82 bytes
Byte offset 106 Command flag and parameters 8 bytes
Byte offset 114 unused 12 bytes
Byte offset 126 Checksum unsigned short
Byte offset 128 MCA state unsigned short See CMD_QUERY_POWER
Byte offset 130 unused 2 bytes
54