GBS Elektronik MCA-527 Firmware Commands - Manual (Page 20)

MCA527
Command name CMD_SET_TIME
Compatibility New MCA527 command.
Execution right Necessary
Description The command sets the time (t) on the internal clock.
Bit 31 … 17:
days since January 1, 2008
Bit 16 … 12: hours (0 … 23)
Bit 11 … 6: minutes (0 … 59)
Bit 5 … 0: seconds (0 … 59)
Format integer integer 32 bit integer integer
Parameter preamble command t 0 end flag
Byte string (HEX) A5 5A 04 01 t
l
... … t
h
00 00 B9 9B
Command name CMD_SET_IP_ADDRESS
Compatibility New MCA527 command.
Execution right Necessary
Description The command allows to set a customized IP address. If the IP address is set to 0.0.0.0, the MCA is
instructed to obtain the IP address from a DHCP server or if not available, to use Zero Configuration
Networking (also named Automatic Private IP Addressing).
Format integer integer char char char char integer integer
Parameter preamble command ip1 ip2 ip3 ip4 0 end flag
Byte string (HEX) A5 5A 0B 01 ip1 ip2 ip3 ip4 00 00 B9 9B
Command name CMD_SET_COMMON_MEMORY_FILL_STOP
Compatibility New MCA527 command.
Execution right Necessary
Description The command sets the fill stop for the common memory. The MCA acquires data until the preset
number of bytes has been written. The common memory is used by the following general modes:
1 = Transient recorder (records ADC raw data)
3 = Time stamp recorder (records the timestamps of level triggered signals)
4 = Time stamp recorder (records the timestamps of edge triggered signals)
5 = Time stamp recorder (AHRC = analog high rate counting)
stop: 0 … common memory size (see CMD_QUERY_STATE527_EX)
Format integer integer long integer integer
Parameter preamble command stop 0 end flag
Byte string (HEX) A5 5A 17 01 stop
l
... ... stop
h
00 00 B9 9B
Remarks For the time stamp recorders, this command is not the only way to preset an automatic stop
condition. This can also be done with the command CMD_SET_PRESETS.
20