Ivoclar Vivadent IPS e.max CAD-on - Manual (Page 22)

22
Load the veneering structure to the milling preview in the Design
menu by clicking on Editing the veneering structure
Note: The milling procedure for the framework should start only
now (see next image), as the milling preview of the veneering
structure can otherwise not be loaded.
Select the Endo mode in the milling preview in order to ensure that
an even joint gap is achieved between framework and veneering
structure.
Select Ivoclar Vivadent IPS e.max ZirCAD in the block selection and
the desired block size prior to the milling process for the framework.
Then start the milling process.
Select Ivoclar Vivadent IPS e.max CAD in the block selection and the
desired block size prior to the milling process for the veneering
structure. Then start the milling process.