Ivoclar Vivadent IPS e.max CAD-on - Manual (Page 34)

34
The IPS e.max CAD veneering structure is in the correct position when it sits evenly on the
ridge of the IPS e.max ZirCAD framework.
Hold the occlusal surface of the restoration against the vibrating plate of the Ivomix. At the
same time, apply slight pressure against the IPS e.max ZirCAD framework in order to evenly
insert it into the IPS e.max CAD veneering structure.
Insert the IPS e.max ZirCAD framework in the correct position into
the IPS e.max CAD veneering structure.
... evenly distribute the IPS e.max CAD Crystall./Connect material by means of the vibrator.
Cleaning, Checking
After the fusion process, the restoration is cleaned and the fusion result is checked. To do so, observe the following
procedure:
– Before cleaning, allow the restoration to dry for a short time.
– Carefully remove excess IPS e.max CAD Crystall./Connect material from the occlusal and proximal area as well as around
the restoration margins by means of the IPS Spatula.
– Smooth out the IPS e.max CAD Crystall./Connect material at the fusion joint.
– Carefully remove all residue of IPS e.max CAD Crystall./Connect material from the IPS e.max CAD veneering structure
(e.g. occlusal aspect) by means of the IPS Spatula or a dry short-haired brush.
– Check the cavities of the IPS e.max ZirCAD framework, remove any residue of IPS e.max CAD Crystall./Connect material
with the IPS Spatula or a brush.
– Checking in the articulator: Is the final occlusal position achieved? If not, the IPS e.max ZirCAD framework and the
IPS e.max CAD veneering structure have not been correctly joined. In this case, the fusion process has to be repeated.
Separate and clean the IPS e.max ZirCAD framework and the IPS e.max CAD veneering structure under running water
before repeating the procedure.
– Do not re-use the Ivomix on the joined restoration.
Preparation Fusion process
Cleaning,
checking
Fusion/
Crystallization
firing