LSC Lighting maXim Quick Reference - Manual (Page 20)

maXim Quick Reference Manual V1.1
Page 16 LSC Lighting Systems (Aust) Pty. Ltd.
7.2.9 Times
To change the times of a parameter;
press and HOLD
[PM] (parameter to change).
Tap the ends of the displayer to select either.
Mov.
Move time.
Dly Delay time that must expire before the Move time starts.
Flags----. Flags shows which flags (if any) have been set to yes.
Tapping the centre of Flags selects the FLAGS menu. When the FLAGS menu is selected,
tapping either end of the displayer steps through the available flags. Tapping the centre of a
displayer selects that flag.
Flags: - - - No Flags
Flags: - P - As Pan
Flags: EP - End Pan
Flags: - T - As Tilt
Flags: ET - End Tilt
Flags: - - C As Chase
When the As Chase flag is set to Yes, this parameter when played back as part of a CHASE,
will ignore the time setting and instead use the crossfade setting of the chase.
7.2.10 Record Scene
To record a scene of the entire output, press;
[record scene] [page] (optional) [F/A] (scene number).
7.2.11 Store
To store a scene of only selected (flashing) parameters, press;
[store] [page] (optional) [F/A] (scene number).
7.2.12 Store + Level
To store a scene consisting of;
??
Selected (flashing) parameters.
??
All intensity levels on the output.
??
All parameters of any fixtures not loaded on the PatPad but with an intensity above zero
on the output. press;
[store + level] [page] (optional) [F/A] (scene number)
7.3 EDITING
7.3.1 Edit Scene
To edit a scene in the current page, press
[edit] [F/A] (scene number).
To edit a scene in a different page, press
[edit] [red page] or [blue page] [F/A] (Scene number).
The fixtures are loaded onto the PaTPad. Use the PaTPad in the normal way to alter (edit) any
parameter settings.
When finished editing, press [edit]
The changes are saved according to the maxim rule;
Only FLASHING parameters will be INCLUDED.