LSC Lighting maXim Quick Reference - Manual (Page 22)

maXim Quick Reference Manual V1.1
Page 18 LSC Lighting Systems (Aust) Pty. Ltd.
8.3 RESET
8.3.1 System Reset
Performing a system reset will not affect any of the recorded memory or settings, except that
the maXim resumes operation in PRESET mode with the patch bypassed.
Press and hold
[function] tap [F/A] (reset), release [function]
The display asks “Do SYSTEM RESET?”. Press [yes], [yes].
8.3.2 Total Reset
Total Reset will ERASE all the recorded memory from the maXim and reset the operating
system. All Scenes, Stacks Chases and Patches are erased. The maXim resumes operation in
PRESET mode with the patch bypassed.
Press and hold
[function] tap [F/A] (reset), release [function]
The display asks “Do SYSTEM RESET?”. Press [no]
The display asks “Do TOTAL RESET?”. Press [yes]
The display asks “RESET will clear all memories - Continue?”. Press [yes]
8.3.3 Power On Resets
To perform a “system reset” at power on, hold
[function], switch on the power, release
[function]. To perform a “total reset” at power on, hold [no], switch on the power, release [no].
8.3.4 Hardware Reset
To perform a hardware reset, remove the power then insert a small insulated pointer to press
the RESET switch on the rear of the maXim beside the DMX Universe1 connector by.
Re-connect the power and switch on.
8.4 SETUP PREFERENCES
8.4.1 Default Times
To set your own default times that are used when you record scenes (in and out), stacks (in, out
and link) and chases (speed and crossfade %) Press and hold
[function] tap [F/A] (set-up).
The display asks “Set Preferences?”. Press [yes] “Set default times and speeds?”.
Press [yes]. Follow the prompts and set the times with the EDIT wheel. When a time is set
lower than 0 seconds, it will be controlled by the manual “time” fader.
To accept the setting, press
[ok]
8.4.2 Yellow Master Inversion
To invert the operation of the Yellow Master:
Press and hold
[function] tap [F/A] (set-up).
The display asks “Set Preferences?”. Press [yes] “Set default times and speeds?”.
Press [no]. “Set Language default?”. Press [no]. “Set FILE NAME Default?”.
Press [no]. “Set Yellow Master Inversion?”, Press [yes]
The display asks “Yellow Master is not inverted – Invert?” Press [yes]