Marantz NR1603 - Manual (Page 32)

29
Error messages
NOTE
• An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the
necessary measures. Then perform Audyssey® Setup again.
• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
• Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
Audyssey Setup
Retry
Caution! : Please check the cable connection and retry.
Microphone or Speaker is none
• The connected setup microphone is broken, or a device other than the
supplied setup microphone is connected.
• Not all speakers could be detected.
• A front speaker (left) was not properly detected.
• Connect the included setup microphone to the SETUP MIC jack of this unit.
• Check the speaker connections.
Audyssey Setup
Retry
Caution!
Ambient noise is too high or level is too low
• There is too much noise in the room for accurate measurements to be
made.
• Speaker or subwoofer sound is too low for accurate measurements to be
made.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers are
facing.
• Adjust the subwoofer’s volume.
Audyssey Setup
Retry
Caution! : Please check the cable connection and retry.
Front R :None
• The displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot be
detected.)
• Check the connections of the displayed speaker.
Audyssey Setup
Retry Skip Error Phase Info.
Caution! : Please check the cable connection and retry.
Front R :Phase
• The displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front right
speakers are reversed.)
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, use
o p
to select “Skip Error”, then press ENTER .
Set up speakers (Audyssey® Setup)
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mations
Basic v
ersion
DVD