Marantz SR4001 - Manual (Page 10)

7
ENGLISH
REAR PANEL
SR4001
R R SR SR
C C
SW SW SBR SBR
SL SL SBL SBL L L
R R
SPEAKER SYSTEMS : MINIMUM 6 OHMS SPEAKER SYSTEMS : MINIMUM 6 OHMS
CENTER CENTER
R R
FRONT FRONT SURROUND BACK SURROUND BACK S. SPEAKER B S. SPEAKER B SURROUND SURROUND
L L L L L L R R
COAX COAX IN IN
OUT OUT
RC-5 RC-5 2 2 1 1
4 4 3 3
OPT OPT DIGITAL OUT DIGITAL OUT ( (AUX2 AUX2) ) 7.1CH INPUT 7.1CH INPUT
L L SL SL C C SBL SBL
R R SR SR SW SW SBR SBR
R R
L L
FM FM ( (75 75 Ω Ω)) GND GND AM AM
C C R R //P P R R C C B B //P P B B Y Y
ANTENNA ANTENNA
DIGITAL IN DIGITAL IN OUT OUT IN IN CDR/MD CDR/MD OUT OUT IN IN TAPE TAPE CD CD VCR1 VCR1 DVD DVD TV TV AUDIO AUDIO DSS/VCR2 DSS/VCR2 IN IN IN IN OUT OUT
AC IN AC IN
MODEL NO. SR4001 MODEL NO. SR4001
C C R R //P P R R C C B B //P P B B Y Y DSS/VCR2 DSS/VCR2 TV TV DVD DVD VCR IN VCR IN VCR OUT VCR OUT MONITOR OUT MONITOR OUT
INPUT INPUT 3 3
INPUT INPUT 1 1
INPUT INPUT 2 2
S-VIDEO S-VIDEO
VIDEO VIDEO
PRE OUT PRE OUT
INPUT 2 INPUT 2 OUTPUT OUTPUT INPUT 1 INPUT 1
HDMI Ver 1.1 HDMI Ver 1.1
COMPONENT COMPONENT VIDEO VIDEO
MONITOR MONITOR OUT OUT
1.25A 150W 1.25A 150W
AC OUTLETS AC OUTLETS 120V 60Hz 120V 60Hz
UNSWITCHED UNSWITCHED
SWITCHED SWITCHED
1.25A 150W 1.25A 150W
FLASHER FLASHER IN IN
!0 u i y
!1 q r !6
!5
!3
!4
w
o
t !8
SR5001
XM XM
RS-232C RS-232C SPEAKER C SPEAKER C OFF OFF ON ON
FLASHER FLASHER IN IN DC DC TRIGGER TRIGGER
R R SR SR
C C
SW SW SBR SBR
SL SL SBL SBL L L
COAX COAX IN IN
OUT OUT
RC-5 RC-5 1 1
4 4 3 3
OPT OPT DIGITAL OUT DIGITAL OUT ( (AUX2 AUX2) ) 7.1CH INPUT 7.1CH INPUT
L L SL SL C C SBL SBL
R R SR SR SW SW SBR SBR
R R
L L
FM FM ( (75 75 Ω Ω)) GND GND AM AM
C C R R //P P R R C C B B //P P B B Y Y ANTENNA ANTENNA
OUT OUT IN IN CDR/MD CDR/MD OUT OUT IN IN TAPE TAPE CD CD VCR1 VCR1 DVD DVD TV TV AUDIO AUDIO DSS/VCR2 DSS/VCR2 IN IN IN IN OUT OUT
C C R R //P P R R C C B B //P P B B Y Y DSS/VCR2 DSS/VCR2 TV TV DVD DVD VCR IN VCR IN VCR OUT VCR OUT MONITOR OUT MONITOR OUT
INPUT INPUT 1 1
INPUT INPUT 2 2
S-VIDEO S-VIDEO
VIDEO VIDEO
PRE OUT PRE OUT
INPUT 2 INPUT 2 OUTPUT OUTPUT INPUT 1 INPUT 1
HDMI Ver 1.1 HDMI Ver 1.1 COMPONENT COMPONENT VIDEO VIDEO
MODEL NO. SR5001 MODEL NO. SR5001
C C R R //P P R R C C B B //P P B B Y Y
INPUT INPUT 3 3
MONITOR MONITOR OUT 2 OUT 2
2 2 3 3 DIGITAL IN DIGITAL IN MULTI. MULTI. OUT OUT
R R R R
CENTER CENTER SURROUND SURROUND
R R
SURROUND BACK SURROUND BACK SPEAKER C/MULTI SPEAKER SPEAKER C/MULTI SPEAKER SURR,SURR BACK:MINIMUM 6 OHMS SURR,SURR BACK:MINIMUM 6 OHMS
L L L L L L L L R R
FRONT FRONT B B FRONT FRONT A A
AC IN AC IN
FRONT A OR B,CENTER, FRONT A OR B,CENTER,
FRONT A AND B:MINIMUM 8 OHMS FRONT A AND B:MINIMUM 8 OHMS SPEAKER SPEAKER
SYSTEMS SYSTEMS
1.25A 150W 1.25A 150W
AC OUTLETS AC OUTLETS 120V 60Hz 120V 60Hz
UNSWITCHED UNSWITCHED
SWITCHED SWITCHED
1.25A 150W 1.25A 150W
!0 u !7 i y
!1 q r !6 @0
!5
!8 w
o
t
!3
!2
e !9 !4
t MONITOR OUT
This is a monitor output and each one includes both
composite video and S-video confi gurations. When
connecting two video monitors or televisions, be
aware that the OSD interface can be used with both
MONITOR OUT connections.
y Preamp Outputs
(L, R, SL, SR, SBL, SBR, C)
Jacks for L(front left), R (front right), C (Center), SL
(surround left), SR (surround right), SBL (surround
back left) and SBR (surround back right).
Use these jacks for connection to external power
amplifi ers.
u AC INLET
Plug the supplied power cord into this AC INLET and
then into the power outlet on the wall.
SR4001/SR5001 can be powered by 120V AC only.
i AC OUTLETS
Connect the AC power cable of component such as
a DVD or CD player to this outlet.
The marked SWITCHED provides power only when
the SR4001/SR5001 is turned on and is useful for
components which you use every time you play your
system.
Caution:
• In order to avoid potential turn-off thumps, anything
plugged into these outlets should be powered up
before the SR4001/SR5001 is turned on.
• The capacity of this AC outlet is 150W. Do not
connect devices that consume electricity more than
the capacity of these AC outlet. If the total power
consumption of the connected devices exceeds the
capacity, the protection circuit shuts down the power
supply.
o Speaker outputs terminals
Seven terminals are provided for the front left,
front right, front center, surround left, surround
right, surround back left and surround back right
speakers.
Note:
You can use surround back speaker terminals as M
(Multiroom) SPEAKER B terminals, when you use
no surround back speaker.
q VIDEO IN/OUT (TV, DVD, VCR1, DSS/
VCR2)
These are the video inputs and outputs. There
are 4 video inputs and 2 video outputs and each
one includes both composite video and S-video
confi gurations. Connect VCRs, DVD players, and
other video components to the video inputs.
The 2 video output channels can be used to be
connected to video tape recorders for making
recordings.
The input signals of video and S-video are converted
each other, and each of the converted video signals
can be output.
w FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial
cable, or a cable network FM source.
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the
terminals marked “AM” and “GND”. The supplied AM
loop antenna will provide good AM reception in most
areas. Position the loop antenna until you hear the
best reception.
e RS-232C (SR5001 only)
The RS-232C port is to be used in conjunction with
an external controller to control the operation of the
SR5001 by using an external device.
r COMPONENT VIDEO INPUT/
OUTPUT
If your DVD player or other device has component
video connectors, be sure to connect them to
these component video connectors on the SR4001/
SR5001. The SR4001/SR5001 has two component
video input connectors to obtain the color information
(Y, C
B , C R ) directly from the recorded DVD signal or
other video component and one component video
output connector to output it directly into the matrix
decoder of the display device.
By sending the pure DVD component video signal
directly, the DVD signal forgoes the extra processing
that normally would degrade the image. The result is
vastly increased image quality, with incredibly life like
colors and crisp detail.
When the video convert function is enabled, video and
S-video images can be output to the COMPONENT
MOINTOR OUT jack.