Marantz SR4001 - Manual (Page 52)

49
ENGLISH
TECHNICAL
SPECIFICATIONS
FM TUNER SECTION
Frequency Range ................................ 87.5 – 108.0 MHz
Usable Sensitivity ............................IHF 1.8 µV/16.4 dBf
Signal to Noise Ratio ................... Mono/Stereo 75/70 dB
Distortion ......................................Mono/Stereo 0.2/0.3 %
Stereo Separation .........................................1 kHz 45 dB
Alternate Channel Selectivity .................± 300 kHz 60 dB
Image Rejection .........................................98 MHz 70 dB
Tuner Output Level ........... 1 kHz, ± 75 kHz Dev 800 mV
AM TUNER SECTION
Frequency Range ................................... 520 – 1710 kHz
Signal to Noise Ratio .............................................. 50 dB
Usable Sensitivity .................................... Loop 400mV/m
Distortion ...................................400Hz, 30 % Mod. 0.5 %
Selectivity .................................................± 20 kHz 70 dB
AUDIO SECTION (SR4001)
Power Output (20 Hz – 20 kHz/THD=0.08%)
Front L&R ............................................8 ohms 80 W / Ch
Center ..................................................8 ohms 80 W / Ch
Surround L&R ......................................8 ohms 80 W / Ch
Surround Back L&R .............................8 ohms 80 W / Ch
Front L&R ..........................................6 ohms 105 W / Ch
Center ................................................6 ohms 105 W / Ch
Surround L&R ....................................6 ohms 105 W / Ch
Surround Back L&R ...........................6 ohms 105 W / Ch
Input Sensitivity/Impedance ...............168 mV/ 47 Kohms
Signal to Noise Ratio(Analog Input / Pure Direct) .... 105 dB
Frequency Response
(Analog Input / Pure Direct)
........................................... 8 Hz – 100 kHz (± 3 dB)
(Digital Input / 96 kHz PCM)
............................................ 8 Hz – 45 kHz (± 3 dB)
AUDIO SECTION (SR5001)
Power Output (20 Hz – 20 kHz/THD=0.08%)
Front L&R ............................................8 ohms 90 W / Ch
Center ..................................................8 ohms 90 W / Ch
Surround L&R ......................................8 ohms 90 W / Ch
Surround Back L&R .............................8 ohms 90 W / Ch
Front L&R .......................................... 6 ohms 110 W / Ch
Center ................................................ 6 ohms 110 W / Ch
Surround L&R .................................... 6 ohms 110 W / Ch
Surround Back L&R ........................... 6 ohms 110 W / Ch
Input Sensitivity/Impedance ...............168 mV/ 47 Kohms
Signal to Noise Ratio(Analog Input / Pure Direct) .... 105 dB
Frequency Response
(Analog Input / Pure Direct)
........................................... 8 Hz – 100 kHz (± 3 dB)
(Digital Input / 96 kHz PCM)
............................................ 8 Hz – 45 kHz (± 3 dB)
MULTI SPEAKER
DIGITAL R L VIDEO S-VIDEO AUX 1 INPUT AUDIO
SETUP SIMPLE MULTI PURE
T-MODE
SURROUND MEMORY DISPLAY ATT MUTE
STANDBY
PHONES POWER ON/OFF
INPUT SELECTOR VOLUME
UP DOWN
AV SURROUND RECEIVER SR5001
DIRECT
AUTO HT-EQ EXIT MENU
MODE
BAND
CLEAR
ENTER
6-5/16 ins. (160 mm)
9/16 ins. (14 mm)
5-3/4 ins. (146 mm)
17-5/16 ins. (440 mm)
13/16 ins. (20 mm)
29/32 ins. (23 mm)
13-7/16 ins.
(341 mm)
15-1/8 ins. (384 mm)
DIMENSIONS
GENERAL MALFUNCTION
If the equipment malfunctions, this may be because
an electrostatic discharge or AC line interference has
corrupted the information in the equipment memory
circuits. Therefore:
- disconnect the plug from the AC line supply
- after waiting at least three minutes, reconnect
the plug to the AC line supply
- re-attempt to operate the equipment
Memory backup
• In case a power outage occurs or the power
cord is accidentally unplugged, the SR4001/
SR5001 is equipped with a backup function
to prevent memory data such as the preset
memory from being erased.
HOW TO RESET THE UNIT
MULTI SPEAKER
DIGITAL R L VIDEO S-VIDEO AUX 1 INPUT AUDIO
SETUP SIMPLE MULTI PURE
T-MODE
SURROUND MEMORY DISPLAY ATT MUTE
STANDBY
PHONES POWER ON/STANDBY
INPUT SELECTOR VOLUME
UP DOWN
AV SURROUND RECEIVER SR5001
DIRECT
AUTO HT-EQ EXIT MENU
MODE
BAND
CLEAR
ENTER
Should the operation or display seem to be abnormal,
reset the unit with the following procedure.
To turn on the SR4001, press and hold the
7.1CH
INPUT and ATT buttons simultaneously for 3
seconds or more.
To turn on the SR5001, press and hold the
MULTI
and ATT buttons simultaneously for 3 seconds or
more.
Remember that the procedure will reset the settings
of the SOURCE, Surround mode, delay time, TUNER
PRESET etc., to their initial settings.
VIDEO
Television Format ....................................................NTSC
Input Level/Impedance ........................... 1 Vp-p/75 ohms
Output Level/Impedance ......................... 1 Vp-p/75 ohms
Video Frequency Response .......5 Hz to 8 MHz (– 1 dB)
Video Frequency (Component) ....5 Hz to 80 MHz (– 1 dB)
S/N .......................................................................... 60 dB
GENERAL (SR4001)
Power Requirement .................................AC 120 V 60Hz
Power Consumption .............................................. 450 W
Weight ................................................. 25.1 lbs (11.4 Kg)
GENERAL (SR5001)
Power Requirement .................................AC 120 V 60Hz
Power Consumption .............................................. 500 W
Weight ................................................. 27.1 lbs (12.3 Kg)
ACCESSORIES
Remote Control Unit RC5001SR ................................... 1
AAA-size batteries ........................................................ 2
FM Antenna ................................................................... 1
AM Loop Antenna .......................................................... 1
Front AUX Jack Cover .................................................. 1
AC Power Cord ............................................................. 1
Warranty Card (USA × 1, Canada × 1)
Specifi cations subject to change without prior notice.