Communication ports – NavCom NCT-2030M Rev.C User Manual
Page 27
Advertising
NCT-2030M User Guide - Rev. C
Communication Ports
Connect the supplied
LEMO
7-Pin end of the NavCom
serial cable (NavCom
P/N
94-310059-3006) to
COM 2
(factory default Control Port) connector of the NCT-
2030M. Connect the
DB9
end to your serial controlling
device. Note that some devices may require an
additional adaptor, as the receiver is configured as a
DCE device.
By factory default
COM 2
is the control port for the
NCT-2030.
COM 1
can be designated as the control
port by using the appropriate NavCom
proprietary
commands
. NOTE: Some output data types, such as
NMEA messages, cannot output on the Control Port
Figure 8: Communication Port Connections
3-25
Advertising