NavCom NCT-2030M Rev.C - Manual (Page 44)

NCT-2030M User Guide - Rev. C
The Event Input can be triggered on the Rising or
Falling edge of the input pulse. Configuration is
possible thru Navcoms StarUtil program. Figure D2
shows a screen capture of the programs PPS & Event
Latch window.
Figure D2: PPS & Event Latch Configuration
Next, the Event Latch message (0xB4) must be enabled
in the NCT 2000 Message Output list. The Message
Rate for the 0xB4 must be set to “On Trigger”. This is
carried out by Right- Clicking on the Rate area adjacent
to the B4 Message ID, and following the menus as seen
in Figure D3. Once configured. the Event Latch
Message 0xB4 will only be output when the chosen
pulse edge of the incoming event is sensed by the
receiver.
Figure C3: Event Latch Output Rate Configuration
C-42