NavCom NCT-2030M Rev.C - Manual (Page 35)

NCT-2030M User Guide - Rev. C
Maintenance
The NavCom equipment may be cleaned using a new
lint free cloth moistened with pure alcohol.
Connectors must be inspected, and if necessary cleaned
before use. Always use the provided connector
protective caps to minimize moisture and dirt ingress.
Cables should be regularly inspected for kinks and cuts
as these may cause interference and equipment failure.
Damp equipment must be dried at a temperature less
than +40°C (104°F), but greater than 5°C (41°F) at the
earliest opportunity.
External Power Source
The NCT-2030M can be external powered using
optional NavCom cable (
P/N 94-310060-3010). This
must be connected to the chosen external power
solution in accordance with Chapter 2
Interfacing\Electrical Power. It is important that the
external power source allow sufficient current draw for
proper operation. Insufficient supplied current will
cause damage to your external power source.
If your chosen external power source is a disposable
battery, please dispose of the battery in accordance
with your local regulations.
5-33