Remotec ZRC-100 V1.53 - Manual (Page 10)

10
Operations
The ZRC‐100 remote controller can be set up as a Primary or
Secondary Controller within a Z‐Wave network.
The ZRC‐100 can control Z‐Wave devices individually or as a group
using Scene or Association. A single Z‐Wave network can include 232
nodes. If necessary, more than one network can be bridged to extend
the number of nodes supported, although this is normally not needed
in a residential environment.
ZRC-100 control capability
Total number of controllable
End‐point (EP) / device / sensor
128 items
(listed on the “Device” and “Sensor” page)
Total number of thermostats 6 thermostats
(listed on the “Comfort” page)
Total number of scenes 12 scenes (listed on the “Scene” page)
Each Scene supports up to 32 Z‐Wave devices or End‐point (EP)
Network Setup (C1)
Rediscover N.W. (C5)
(Rediscover network)
Delete Dead Node (C6)
Listening Mode (C7)
Scan Devices (C2)
+
• Press and hold cd keys simultaneously for 3
seconds to enter Network Setup menu.
• Press BACK key to go back to previous page.
• Press and hold BACK key for 2 seconds to go
back to root menu.
Network
Setup
menu
Create Sec. (C4)
(Create secondary)
Create Pri. (C3)
(Create primary)
Learning Mode (C1)