Remotec ZRC-100 V1.53 - Manual (Page 45)

45
4
Place the two controllers
close to each other.
(LCD display OK if the
learning mode is
successful.
LCD display ERROR if the
learning mode is
unsuccessful.)
⇓
L CAUTION
Scene Controller Configuration Command and Association Command
If scenes are copied to a secondary controller using the replication
function, those scenes cannot be modified using the Scene Controller
Configuration and Association Commands. If modifications are desired, it
is recommended to delete all these scenes from the controller prior to
using the two aforementioned commands.
Scan Devices from network
In most cases, Z-Wave gateway is the primary controller (control
center), all Z-Wave devices will be added / (inclusion) by the Z-Wave
gateway. Normally, it is need to click the PROG button of the Z-Wave
device to add into the network and one by one. The gateway will create
a control page / section to Z-Wave devices. User can control / monitor
Z-Wave devices under the control page.
ZRC-100 can discover all existing Z-Wave devices from the network
and no need to click the PROG button one by one, discovered devices
will be re-assigned to their default categories (Devices, Comforts and
Sensors), and names will be re-assigned with default naming in
ascending order which is implemented by the function of “Scan
Devices”.
Learning Mode
Learning…
>>>>
>>>>
OK
Learning Mode
Learning