Remotec ZRC-100 V1.53 - Manual (Page 6)

6
ZRC‐100 Operations
Welcome to the world of Z‐Wave home automation, you can use your
ZRC‐100 to control almost every Z‐Wave certified products inside your
house. The following section will guide you through the set up
processes and operation procedures for your ZRC‐100.
Please note that all Z‐Wave devices, light switches, dimmers, shutter
switches, thermostat and secured door lock made from various
vendors are compatible with your ZRC‐100 as long as they are Z‐Wave
certified or carry the following Z‐Wave logo:
(Please carefully read through the following sections of this user
manual and store for future reference.)
Before using the ZRC‐100, please install the batteries:
• 4xAAA batteries are required for operation.
• Remove the battery cover on the back of your remote.
• Check the polarity of the batteries and the "+/‐" marks inside the
battery compartment.
• Insert the batteries.
• Push the battery cover back in place.
L CAUTION (battery safety)
− Use new batteries of the recommended type and size only.
− Never mix used and new batteries together.
− To avoid chemical leaks, remove batteries from the remote
controller if you do not intend to use the remote for an
extended period of time.
− Dispose of used batteries properly; do not burn or bury them.