Remotec ZRC-100 V1.47 - Manual (Page 10)

10
Operations
The ZRC-100 remote controller can be set up as a Primary or
Secondary Controller within a Z-Wave network.
The ZRC-100 can control Z-Wave devices individually or as a group
using Scene or Association. A single Z-Wave network can include 232
nodes. If necessary, more than one network can be bridged to extend
the number of nodes supported, although this is normally not needed in
a residential environment.
ZRC-100 control capability
Total number of controllable
End-point (EP) / device / sensor
128 items
(listed on the “Device” and “Sensor” page)
Total number of thermostats 6 thermostats
(listed on the “Comfort” page)
Total number of scenes 12 scenes (listed on the “Scene” page)
Each Scene supports up to 32 Z-Wave devices or End-point (EP)
Network Setup (C1)
Rediscover N.W. (C2)
(Rediscover network)
Delete Dead Node (C4)
Listening Mode (C5)
Re-scan Devices (C3)
+
• Press and hold cd keys simultaneously for 3
seconds to enter Network Setup menu.
• Press BACK key to go back to previous page.
• Press and hold BACK key for 2 seconds to go
back to root menu.
Network
Setup
menu
Create Sec. (C6)
(Create secondary)
Create Pri. (C7)
(Create primary)