Remotec ZRC-100 V1.47 - Manual (Page 49)

49
⇓
3
Select “Create a Sec.”
then press key.
4
Please make sure the
target secondary
controller is setup to
receive information
mode.
(e.g. target secondary
controller should entry
the “Learning mode＂
if this is a another ZRC-
100. Please refer to the
target controller user
manual for more
information)
=> Target secondary
controller will act as a
secondary controller
after this action.
=> Original ZRC-100
primary controller will
still keep in a primary
controller after this
action.
⇓
Create a Primary Controller
(Transferring Only Network Information to a New Primary Controller)
You can just transfer network information to another remote so that it
will act as a new primary remote. This primary shift is done by
following the steps below.
Create a Sec.
Copying…
>>>>
Create a Sec.
Copying…
>>>>
OK
Network Setup
Rediscover N.W. >
Delete Dead Node >
OK to Enter
Re-scan Devices >
Network Setup
Listening Mode >
OK to Enter
Create a Sec. >
Create a Pri >