Remotec ZRC-100 V1.47 User Manual
Page 13
13
2
Select “Delete
Device＂.
3
Press
key to delete
the device from Z-Wave
network.
4
Press the program button
on the target device.
⇓
Note 1: If no ACK signal received for more than 60 seconds, the
“Delete Device” mode will exit automatically.
Note 2: In a Z-Wave network, only the primary controller or inclusion
controller can delete or exclude devices into its network. If ZRC-100 is
configured as a secondary controller, it will report “Error” if users
attempt to use ZRC-100 to delete a device from its network.
Setup
Add Device
>
Delete Device
>
Add to Scene
>
OK to Enter
Delete Device
Press PROG on target
>>>>
Saving Data …
Delete Device
Press PROG on target
>>>>
OK
Delete Device
Press PROG on target
>>>>
Setup
Add Device
>
Delete Device
>
Add to Scene
>
OK to Enter