Remotec ZRC-100 V1.47 - Manual (Page 44)

44
Re-scan (Rediscover) Devices from network
In most cases, Z-Wave gateway is the primary controller (control
center), all Z-Wave devices will be added / (inclusion) by the Z-Wave
gateway. Normally, it is need to click the PROG button of the Z-Wave
device to add into the network and one by one. The gateway will create
a control page / section to Z-Wave devices. User can control / monitor
Z-Wave devices under the control page.
ZRC-100 can discover all existing Z-Wave devices from the network
and no need to click the PROG button one by one, discovered devices
will be re-assigned to their default categories (Devices, Comforts and
Sensors), and names will be re-assigned with default naming in
ascending order which is implemented by the function of “Re-scan
Devices”.
To implement this function, your ZRC-100 is needed to follow below
steps:
1) Assume all Z-Wave devices have been added by gateway.
2) ZRC-100 should act as a secondary controller (receive all
network and device information from a primary controller),
please refer to “Learning Mode” section in this manual.
3) Execute the “Re-scan Devices” function with below steps.
Step Setup Key LCD Indication
1
Press and hold cb keys
simultaneously for 3
seconds under the Home
page.
⇓
2
Select “Re-scan
Devices” and press
key.
Home
Device >
Scene >
Comfort >
OK to Enter
Network Setup
Rediscover N.W. >
Delete Dead Node >
OK to Enter
Re-scan Devices >
Network Setup
Rediscover N.W. >
Delete Dead Node >
OK to Enter
Re-scan Devices >