Remotec Z-URC550 V1 - Manual (Page 11)

11
Note2: This process will only remove the group devices from its
assigned group but will not exclude it from the network.
Note 3: The above steps are needed if Z-URC
TM
550EU to be a
secondary remote controller and the Group information mapping from
gateway / primary controller is unsuccessful.
Group Operation
After adding devices to your Z-URC
TM
550EU using XpressZetup
TM
,
you can turn the device on/off or up/down via the corresponding group
control keys in front (Figure 3).
• For on/off switches, press
key to turn on the devices and
key to turn them off. (use to extend 16 groups On/Off)
• To operate dimmer switches and curtain motors, hold the
key
to open the curtain or dim up the light. By holding the key you
can retract the curtain or dim down the light.
• You can turn on all the devices in the network by pressing All-On
key and turn them off via All-Off key.
• The green “OK＂ LED flashes when the operation is successful,
and the red ERROR LED flashes when it’s failed.
Figure 3 Group Control Keys of the Z-URC
TM
550EU
Group
Control Keys
All On/Off
Keys