Remotec Z-URC550 V1 - Manual (Page 35)

35
L IMPORTANT
− If the power on/off function of your device is not infra-red
controlled, you need to follow steps 2 to 6 above and start
searching.
− Press
and another function key alternately until your
device responds to the expected function, then press the same
Device Mode Key (e.g. TV) to lock in the code.
e.g. Press & alternately, or ;
−
Press & alternately.
Notes:
−
TV, SAT/CBL, DVD, and other device codes can be searched
for and locked into any device modes. Simply press the
corresponding device mode key in step 2 & 5 and enter an
appropriate Magic Search Code for your DVD and other
devices.
−
Each time you press the , the Z-URC
TM
550EU will skip
to the next code and send out a POWER signal trying to turn off
your device.
−
If you fail to stop pressing when your device has been
turned off, turn your device on again immediately. Before the
green indicator goes out, press "Mute” on the Z-URC
TM
550EU
to skip backward. Repeat step 7 above and lock in the code.
−
If the red indicator flashes six times after pressing of
key, you are already at the last code of the library. Press "CH
+" and "VOL -" to resume the Z-URC
TM
550EU and repeat the
above procedures carefully to search again.
Learning IR Commands
Your Z-URC
TM
550EU is equipped with learning capability. This
allows you to "teach" your Z-URC
TM
550EU certain functions from
your original equipment remote. Please follow the steps below.
1
Press the desired device mode key (e.g. TV).
2 Press and hold "CH+" and "VOL-" on the Z-URC
TM
550EU
simultaneously for 3 seconds until the green indicator lights up.
3 Enter the learning code "0", "0", "0", "0". The green indicator light
will flash once then stay lit. The Z-URC
TM
550EU is now ready to
learn.
4 Place the Z-URC
TM
550EU and your device remote on a flat
surface, aimed at each other 1-3 inches apart.