Assign association for two devices – Remotec Z-URC550 V1 User Manual

Page 17

Advertising
background image

17

Deleting a group

Step

Setup Key

LED Indication Status

1

Press

in Advance

Setup

• The “OK" light turns

on

2

Select a group number
from 1 to 16 (1-8 or

1-8)

• “OK" LED flashes

once and stays on

• “LED_A" off
• “LED_B" flashes

slowly

• Delete a group

completed


Note1: This process will only remove the group devices/EPs from its
assigned group but will not exclude it from the network.

Note 2: The above steps are needed if Z-URC

TM

550EU to be a

secondary remote controller and the Group information mapping from
gateway / primary controller is unsuccessful.


Assign Association for Two Devices


The Z-URC

TM

550EU can be used to assign one device to

automatically interact directly with another device.

For example you can assign a door sensor (primary node) to turn on the
light switch (secondary node) when the door is opened.

Adding Device/End-point to an Association Group

Step

Setup Key

LED Indication Status

1

Press

in Advance

Setup

• The “OK" light turns

on

2

Press

• “OK" LED flashes

once and stays on

• “LED_A" flashes

slowly

3

Select a group number
from 1 to 16 (1-8 or

1-8)

• “OK" LED flashes

once and stays on

• “LED_A" off
• “LED_B" flashes

slowly

Advertising