Rena Envelope Imager XT 3.0 - Manual (Page 13)

SECTION 2
INSTALLING THE PRINTER
Connecting the Optional Feeder to the Printer
A number of different RENA Feeder models can be used with the Envelope Imager XT3.0/XT4.0.
Note: Please refer to the operations manual provided with your feeder for feeder setup instructions.
A Feeder Interface Cable must be attached between the printer and feeder, as shown in Figure 9 , so that the printer
can stop/start the feeder appropriately.
The feeder interface does NOT control feeder speed. The operator must manually adjust the speed of the feeder to be
slower than the printers transport speed. A gap of approximately 1 inch or more should be present, between each
piece of media as it feeds under the print units. If the speed of the feeder is set too fast, media will over-lap as it
feeds and cause jams in the printer.
Printer Connection
Figure 9
Feeder Connection
(RENA EasyFeed 120 shown)
Please use the appropriate cable (listed below) to connect the printer to your Rena feeder.
FEEDER INTERFACE CABLES
PART # DESCRIPTION
*97E-500-193 CABLE C: EasyFeed 120 Feeder, to Envelope Imager XT3.0/XT4.0 Printer
35E-500-196 CABLE D: EasyFeed 120 Feeder, to T-750 Tabber, and XT3.0/XT4.0 Printer
35E-500-194
CABLE E: EasyFeed 120 Feeder, to T-950 Tabber, and XPS-ProTab4.0 / T-950
Tabber and XT3.0/XT4.0 Printer.
35E-500-197 CABLE F: EasyFeed Lite Feeder, to T-750 Tabber, and XT3.0/XT4.0 Printer
* cable included with printer.
Note: Cables made for use with the EasyFeed 120 feeder may also be used with the RENA
XPS-ProFeed and EasyFeed 200 feeder models.
CAUTION!
These cables can NOT be used with the EasyFeed Lite or AF500 feeder models. Using these cables
with inappropriate feeders will cause damage to the printer and or feeder.
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007
13