Rena Envelope Imager XT 3.0 - Manual (Page 8)

SECTION 1
GETTING ACQUAINTED
Rear View
Figure 3
9
13
15
16
14
10
11 12
17
9. USB PORT – Connects the printer to the USB port of your computer.
10. PARALLEL PORT – Connects the printer to the Centronics Parallel port of your computer.
11.
FEEDER INTERFACE CONNECTOR – Allows connection to an optional feeder, so the
printer can stop/start the feeder appropriately.
12. VACUUM SWITCH – This switch controls the power to the vacuum fans.
13.
MEDIA SIDE GUIDE SECURING KNOBS – Used to secure the positions of the Media
Side Guides.
14
OUTER HOLD-DOWN STRAPS & SECURING KNOBS – Holds down the sides of the
media to help guide it under the printheads.
15.
MEDIA HOLD-DOWN STRAP & SECURING KNOB – Holds down media to help guide
it under the printheads.
16.
MOTOR CIRCUIT BREAKER – The circuit breaker protects the printer’s motor from
overload.
17.
MAIN POWER SWITCH & POWER RECEPTACLE – This assembly contains the Main
Power Switch, Power Receptacle and Line Fuses.
8
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007