Designing your layout – Rena Envelope Imager XT 3.0 User Manual
Page 31
SECTION 3
OPERATING THE PRINTER
5. Once you locate your data file, click on OPEN. The “Link Data Wizard” will appear and it will walk you
through the steps of linking your data file to FlexMail3.
Tip: Selecting zero for “rows to scan” will cause FlexMail3 to scan all rows for data. This may take some
time, but doing so will avoid the loss of fields that may only sporadically contain data.
When selecting “Field Types”; it is suggested that you set your numeric fields (zip code, dpc) as “text”.
6. Once you are finished with the Link Data Wizard, you will be presented with your data file, shown in the
Datasheet view. Take a moment to verify that all data is present and properly defined.
Designing Your Layout
1. Click on the “Designer” view tab (located at the bottom of the screen).
2. Click on File then Print Setup. Select your Rena printer model from the pull down list. Then click on Close.
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007
31