Rena Envelope Imager XT 3.0 - Manual (Page 9)

SECTION 1
GETTING ACQUAINTED
Print Carriage View
18. MEDIA TRANSPORT BELTS – Drives the material through the system.
19. PRINT UNIT SECURING KNOBS – Used to secure the print unit positions.
20.
ENVELOPE IMAGER XT 4.0 PRINT UNIT / MEDIA TRANSPORT GUIDE
Envelope Imager XT 3.0: A Media Transport Guide will be located here. This device can be positioned
to improve material transport.
Envelope Imager XT 4.0: Two additional pen stalls, as shown above.
21.
PRINT UNITS –Hold the inkjet cartridges. Used to adjust the vertical print position.
The Envelope Imager XT 3.0 contains 3 Print Units; one capable of holding a single cartridge, one is
capable of holding 2 ink cartridges and one capable of holding 3 ink cartridges (6 ink cartridges, for a
total of 3” print height)
The Envelope Imager XT 4.0 (shown above) contains 4 Print Units; one is capable of holding 3 ink
cartridges, two are capable of holding 2 ink cartridges each and one is capable of holding 1 ink
cartridge. (8 ink cartridges, for a total of 4” print height)
22. MEDIA SENSOR – Keep this area clean (see Section 4 “Maintenance”).
23. INK CARTRIDGE LATCH LEVERS – Secures the inkjet cartridge into the Pen Stall.
24.
PEN STALL – The area where the inkjet cartridge is inserted.
25.
EXIT ROLLERS – These adjustable rollers help to smoothly eject the media from the unit.
Figure 4
21
19
18
22
20
25
23
24
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007
9