Rena Envelope Imager XT 3.0 - Manual (Page 20)

SECTION 2
INSTALLING THE PRINTER
Paper Feed (Media Transport) Test
Test for proper media transport.
If the printer is setup properly, it should feed the media without hesitation, skewing or jamming.
1. With the printer off-line, press the ENTER key, to start the Paper Feed feature (feeds material without
printing).
2. Press ENTER again to stop the Paper Feed feature.
TEST Print
When off-line, the TEST key can be used to print a TEST image.
The TEST image can be used to:
ƒ Check the vertical print position.
ƒ Demonstrate the printer.
ƒ Check the condition or the ink cartridges.
ƒ Check the function of the printer.
Note: A 6”x9” mail piece is required to print the “factory TEST image” with the Envelope Imager XT 4.0.
A #10 envelope can be used to print the “factory TEST image” with the Envelope Imager XT 3.0.
Horizontal print position is adjusted via your software (mailing program).
Customizing the TEST Print Image:
The TEST print image can be changed to any image you desire, by using the following procedure:
1. Power the printer on while holding down the TEST key.
2. From your computer; send an image that you would like to be the new TEST image.
Note: Turning the printer on, while holding down the TEST key, will erase the previous TEST image. If a new
TEST image is not loaded, then a TEST image will not be available to print when you press the TEST key.
20
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007