Rena Envelope Imager XT 3.0 - Manual (Page 29)

SECTION 3
OPERATING THE PRINTER
Print Heads Tab (Head Adjustment)
The purpose of the Print Heads tab is to permit slight (0.001-inch) horizontal adjustment to the position of the print
heads to each other. The adjustment is used to precisely align the three printheads (cartridges) when printing
graphics or type that extends beyond the height of one printhead. Each head can be moved +/- 0.048-inch in 0.001-
inch increments.
• To adjust the printhead alignment toward the leading edge; decrease (▼) the value.
• To adjust the printhead alignment toward the trailing edge; increase (▲) the value.
When the printer is turned off the changes that you make in this manner go back to the original settings.
Windows 98 Windows NT, 2000, XP
Paper Tab (Invert Printing)
Do NOT try to change the print orientation using the “Invert Printing” feature, shown below.
Instead; to change print orientation, you must load and select the appropriate printer driver:
“Normal” (up-side-down): Load and select the Envelope Imager XT 3.0 or Envelope Imager XT 4.0 driver.
“Invert” (right-side-up): Load and select the Envelope Imager XT 3.0 Invert or Envelope Imager XT 4.0 Invert
driver.
Please be sure to leave this “Invert Printing” selection at its default (“Normal” or “Off”) choice.
Windows NT, 2000, XP
Windows 98
All other Paper Tab features should be left in their Default settings (Paper size is always “Max Print Area” and
Orentation is always set to “Portrait”). Do not change them.
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007
29