Rena Envelope Imager XT 3.0 User Manual
Page 16
SECTION 2
INSTALLING THE PRINTER
IMPORTANT!
The two Outer Transport Belts should be adjusted so they ride over the bottom lip of the Media Side
Guides and are positioned very close the Media Side Guides, but not rubbing against them, as shown in
Figure 17
.
4. Position the Media Hold-Down Strap [2] so that it helps hold the media down, as shown in
Figure 18
.
Figure 18
2
Figure 17
5. If needed; turn on the vacuum assist fans.
The center belt has a vacuum assist feature that can be turned on with the Vacuum Switch located above the
motor circuit breaker, as shown in
Figure 19
. The vacuum assist is useful when feeding smaller and lighter
materials.
Figure 19
16
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007