Rena Envelope Imager XT 3.0 - Manual (Page 22)

SECTION 3
OPERATING THE PRINTER
Section 3 – Operating the Printer
This Section assumes that you have setup the feed system and connected the printer to your computer.
Printer Control Panel & MENU Features
The printer control panel keys can be used to access various functions that help the operator control the printer.
These functions and their operation are as follows:
ENTER key
The ENTER key is used to start/stop media feed. When the printer is placed in any of the Menu modes, the
ENTER key is used to choose the options available in the Menu.
Tip: To allow the printer time to finish printing pieces currently under the print carriage, use the ENTER key to
stop media feed, before taking the printer off-line.
Media Transport (Paper Feed) Test: Pressing ENTER when the printer is off-line, will activate the Paper Feed
Test feature (media will be fed without printing).
TEST key
Pressing the TEST key momentarily, places the printer in the test print mode. The word “Working” appears in
the lower half of the display and after a short period of time the display changes to “Enter to feed”. Pressing the
ENTER key will start the feeding process (test images printing). To stop feeding press, ENTER again.
Tip: A 6” x 9” mail piece is required to print the “factory TEST image” with the Envelope Imager XT 4.0.
To restore the printer to the normal ready mode press the ON LINE key to take the printer off line and then
press and hold the RESET key until the LED on the TEST key blinks. The printer is then restored to its normal
ready state.
Pressing and holding the TEST key will place the printer into the “Service Menu”.
Service Menu: Pressing and holding the TEST key will cause the printer to enter into the “Service Menu” where
the various functions of the printer can be tested. To exit the “Service Menu”, turn the printer OFF, then ON
again. The service menu is primarily used by service technicians to diagnose problems, should they occur. You
can use the “+” or “-” key to scroll through the menu. Pressing the ENTER key will test the function. To
restore the printer to its normal mode, turn it OFF then ON.
MENU key
The MENU key is used to access the special features built into the printer. The basic features are accessed by
momentarily pressing the MENU key. Use the “+” or “-” keys to access the features. The features available
under this mode of operation are as follows:
Media Thickness Setup – This feature is used to set the correct carriage/printhead height for the media being
used. See “Media Thickness Adjustment” for more details. To activate this feature, press ENTER. The Media
Thickness Dial can then be used to change the carriage height.
Press Enter to Purge – The purging function is useful to clear the inkjet cartridge nozzles when the machine
has been sitting idle. To activate the purge, press the ENTER key and feed media.
Clear Batch Counter – Pressing the ENTER key will clear the number in the upper right hand corner of the
display. Resetting the counter is usually performed at the start of each job. Turning OFF the printer will not
reset this counter.
Purge First Piece – Turning the feature ON will cause the printer to send one purge pattern on the first piece.
After the purge is completed the next piece will print the first record of your database.
Address Recovery – In event of a jam or misprint; in the printer you can recover up to the last 9 records by
using this feature. See “Print Recover After a Jam” for details on the use of this feature.
22
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007