RGBLink VSP 5360 - Manual (Page 93)

6. System Setup and Operation
How to Save the Parameter
VSP 5360 User Manual 93
How to Save the Parameter
Push the [SAVE] button, the button light is on, and enable the SAVE
function.
Some of the buttons 0-12 in PRE area are on, and some flash. The buttons
on can be saved, and flash will be overwrite. Push the button on to save,
for example, button 1, OLED shows as follows:
User can also push the [MENU] button to enter the menu item, and choose
<SYSTEM> option, turn the knob and choose <SAVE TO>, show as
follows:
Push the knob to confirm. Turn the knob again, and choose the save
mode, for example, save to mode1, OLED shows as follows:
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
— >SAVE TO > >
RECALL > >
CLEAR SAVE1
CLEAR ALL > >
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
PUSH THE LEDS ARE ON TO SAVE
Button is on can be saved
Button flashes will be overwrite